As a multi-purpose tire, NZBA711 is often used on reach stackers because of its strong stability and good durability. It is a reliable tire in various harsh environments.
However, reach stackers tires are used in the special environment of the port and are used more frequently, and the wear of the tires is relatively large, so it is still necessary to adjust the rubber formula to extend the service life.
Generally speaking, the life of a solid tire in normal use is 4 to 5 years. After 5 years, even if the tire pattern wear is small, try to replace it, because the rubber on the tread will age over time, and there will be many small cracks. It is the cause of the puncture.
However, depending on the tire rubber formula, the vehicle environment and driving habits, the service life of the tire will vary. Therefore, we need to pay more attention when driving, and tire aging is also a sign. For example, the aging parts of the tread mostly start from the edge parts such as the sidewall or shoulder. Long-term sun and rain will cause small loops on the rubber surface. These cracks indicate that the bearing capacity and quality of the tire at this time are both It has already begun to drop, and in order to reduce the risk of puncture, the gold should be replaced as early as possible.
In addition to aging, tires are also subject to natural wear. Before the tire leaves the factory, the wear limit is marked on the sidewall to indicate the real-time wear status of this tire. For tires without wear marks, we can also use calipers to measure. Generally, tires with a groove depth of less than 1.6 mm can no longer be used because the drainage performance and puncture resistance of the tire will be greatly reduced at this time. In addition, if a tire has been repaired three or four times, then we recommend that you try to switch this tire to a non-driving wheel or rear wheel to reduce the risk of puncture.
ENGLISH
русский
